AAP Elite S series Manual de usuario descargar pdf (Pagina 16)

PROGRAMMING YOUR ALARM

GETTING INTO PROGRAM MODE

There are 2 levels of program mode, CLIENT mode and INSTALLER

mode. Normally the installer will give you access to the CLIENT mode so

you can add, delete, or change the user codes.

In CLIENT mode you can program up to 100 individual User Codes that

may be 1-6 digits in length. Each of the 100 Users can be assigned NO

access, LIMITED access or FULL access to CLIENT mode. A User with

FULL access can change all access codes, change the panel time & date,

change the telephone numbers, change the remote control codes (DTMF),

add or remove radio devices, initiate Walk-test mode and access some

diagnostic features. All of these things can be explained in detail by your

installer.

To get into CLIENT mode provided the system is NOT armed press;

The Program LED with turn ON (LED keypad) or

The LCD Keypad will display “CLIENT : USERS”

If you get a single long beep at this point and the above indications do not

happen it means your code cannot access Program mode.

EXITING PROGRAM MODE

To exit out of program mode press;

<PROGRAM> <ENTER> (LED Keypad)

Program LED will turn Off or;

Press and hold <PROGRAM> for 2 seconds (LCD Keypad)

ADDING OR DELETING A USER CODE

Once in CLIENT mode, to program a User code you enter the User code

address (Program location 1) then the code address 1-100. For example

to program User # 3 with a code “2580”, key in the following sequence:

(eg P1E3E2580E)

If there is an existing code already at that address it will be displayed on

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Sin comentarios

AAP Elite S series Manual de usuario Pagina 16