AAP Elite S series Especificaciones descargar pdf (Pagina 14)

Page 14

If you make a mistake use the “$ARM (AAP)” or “STAY$ (CROW)” button to move the cursor towards the left and

make any corrections.

When you are happy with the text Press “ENTER” to save the changes. You can program the text for all zones in the

same way.

KEYPAD ADRESS (P900E)

All LCD keypads connected to the control panel MUST have different addresses programmed otherwise there could

be clashes between multiple keypads on the same address. To change the keypad address enter [PROG]-[900]-

[ENTER. The keypad will display the current keypad address number (set to number 1 by default). Select an unused

number, eg 2, and then press <ENTER> to save the new address. The new address will now be displayed on the top

line of the keypad eg “Local Keypad 2”.

KEYPAD TAMPER SWITCH (P901E)

Some LCD keypads may have a tamper switch fitted. If the switch is fitted, the tamper monitoring is inhibited by de-

fault in programming at local edit address P901E. For the tamper switch to be active you must enable it at address

P901E. After pressing P901E in “Local Edit” mode, pressing any numeric button will toggle the tamper state from dis-

abled to enabled or vice versa. When the desired setting is displayed press <ENTER> to save the new setting.

PROGRAMMING PANEL TYPE (P902E)

The LCD keypad can be connected to many different control panels and the correct type must be set at the keypad

for the text to be displayed correctly for the panel concerned. There are 7 panel types that can be set. The number

you must program to select the correct panel type is shown in the chart below.

Panel type 6 is another variation of the ELITE 64 control panel that now includes the Near & Verified alarm reporting.

The new LCD panel version allows for the memory messages to be displayed correctly for these alarm types.

▼Button # 1st Press 2nd Press 3rd Press 4th Press

1 * (‘) # (<) = (>) 1

2 A (a) B (b) C (c) 2

3 D (d) E (e) F (f) 3

4 G (g) H (h) I (i) 4

5 J (j) K (k) L (l) 5

6 M (m) N (n) O (o) 6

7 P (p) Q (q) R (r) 7

8 S (s) T (t) U (u) 8

9 V (v) W (w) X (x) 9

0 Blank Y (y) Z (z) 0

▼PANEL TYPE # CONTROL PANEL NAME

0 POWERWAVE 4

1 POWERWAVE 8

2 POWERWAVE 16

3 POWERWAVE 64 (V1.01– V1.03)

4 POWERWAVE 64 (V1.04+)

5 ELITE 64

6 ELITE 64 Series II (V2.04+)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 102 103

Sin comentarios

AAP Elite S series Especificaciones Pagina 14