AAP Elite S series Especificaciones descargar pdf (Pagina 62)

Page 62

PROGRAMMING 4+2 REPORT CODES

PROGRAMMING 4+2 REPORT CODESPROGRAMMING 4+2 REPORT CODES

PROGRAMMING 4+2 REPORT CODES

When programming 4+2 report codes (see pages 89-97) you can enter in the digits 1234567890 plus the following

special characters BCDEF. If you enter in a value of “00” or press the “Control” & “0” button after a 4+2 program

address then the selected option will not report via the dialler e.g. P1315E-00-E or P1315E-Control-0-E will disable

keypad panic alarm reporting in 4+2 mode. When using the “Control” “0” keys you must press and hold the Control

key first then press the 0 key within 2 seconds.

The 4+2 event codes must be 2 digits but they can be in any order e.g.;

P1315E-01

-E, or P1315E-C6-E, or P1315E-4F-E, etc.

In the above examples, the letters are programmed using the special function keys listed in the table below. When

displaying the data back at the keypad the associated keypad indications are also listed against the special letters B-

F. (NOTE: A value of “0” in 4+2 will be transmitted as 10 pulses to the monitoring station).

COMMON CONTACT ID CODES

COMMON CONTACT ID CODESCOMMON CONTACT ID CODES

COMMON CONTACT ID CODES

Medical Alarm 100 Low Temperature 159

Medical Pendant 101 High Temperature 158

Fire Alarm 110 Refrigeration Alarm 152

Smoke Detector 111 Water Leakage 154

Heat Detector 114 Gas Detector 151

Manual Call Point 115

Duct Detector 116

Silent Panic 122

Audible Panic 123

Perimeter Zone 131

24 Hour Zone 133

Entry Exit Zone 134

Character LCD KP Special Function Key Displayed as

On LCD KP

“B” “Control” ”2” B

“C” “Control” ”3” C

“D” “Control” ”4” D

“E” “Control” ”5” E

“F” “Control” ”6” F

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 102 103

Sin comentarios

AAP Elite S series Especificaciones Pagina 62