AAP Elite S series Especificaciones descargar pdf (Pagina 6)

Page 6

INPUT CONFIGURATIONS (ZONE WIRING DETAILS)

INPUT CONFIGURATIONS (ZONE WIRING DETAILS)INPUT CONFIGURATIONS (ZONE WIRING DETAILS)

INPUT CONFIGURATIONS (ZONE WIRING DETAILS)

The ELITE 32EX Expander Board has 32 programmable analogue inputs.

The configuration of each input is programmed via the zone groups at addresses P471E—P490E. Through the zone

group programming the hardwired zones can be configured to one of four settings;

Type 1 Single Zone Short circuit input No End-of-Line (EOL).

Type 2 Single Zone 2k2 End-of-Line (EOL) with No Tamper.

Type 3 Single Zone NO (Normally open contact) with Tamper.

Type 4 Single Zone NC (Normally closed contact) with Tamper

The following table shows the end-of-line resistor configurations. The option numbers referred to in the “Zone Type”

column are the options at Zone Group “D” (P471E—P490E).

Zone Type Zone Wiring Tamper

Type 1

Option 1 =On, Option 2 = Off, Option 3 = Off

Loop (Short circuit) None

Type 2

Option 1 =On, Option 2 = On, Option 3 = Off

2k2 None

Type 3

Option 1 =On, Option 2 = On, Option 3 = On

Option 7 = Off

4k7

Normally Open Contact

2k2

Type 4

Option 1 =On, Option 2 = On, Option 3 = On

Option 7 = On

4k7

Normally Closed Contact

2k2

Zone

N/C

Type 1: Short circuit loop, No EOL

N/C

Zone

Type 2: 2k2 EOL, No Tamper

2k2

N/O

4k7

Zone

Type 3 & 4: 2k2 & 4k7 Configuration for Alarm & Tamper monitoring (contacts can be N/C or N/O)

2k2

N/C or N/O

Zone Resistor Tamper Resistor

Tamper Switch

1 2 3 4 5 6 7 8 9 10 11 ... 102 103

Comentarios a estos manuales

Sin comentarios

AAP Elite S series Especificaciones Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad AAP Elite S series