AAP Elite S series Especificaciones descargar pdf (Pagina 15)

Page 15

CHANGING THE AREA SINGLE CHARACTER IDENTIFIER (P998E)

When you enter in [PROG]-[998]-[ENTER] the display will look like the example above. You may edit the single

character Area identifier at this address starting at Area “A” (first left-hand position). The keypad allows for up to 16

areas but the actual number of areas supported on this panel is two. The first character (in this case the ”A

”) is the

identifier used to show the status of the first Area when armed. The second position (in this case the “B”) is the identi-

fier used to show the status of the second Area.

If you preferred to have the first area shown as Area “1” and not “A” then you can change it here using the same

method as used previously. With the cursor underneath the letter “A”, Press the “1” button four times until the

character in the first slot shows “1”.

When you are happy with the changes Press the “ENTER” button to save the changes.

CHANGING THE KEYPAD NAME (P999E)

When you enter [PROG]-[999]-[ENTER] the display will look like the example above. You may enter any name you

wish up to 16 characters in length (using the same method as described for zone names). This name is

displayed at the keypad in Idle mode.

When you are happy with the changes Press “ENTER” to save.

RESETTING INDIVIDUAL TEXT TO DEFAULT or LAST SAVED SETTING

While in “Local Edit Mode” there are two special functions that can be performed at any of the “Local Edit” Program

locations. They are “Return to Default Text” or “Return to Previously Saved Text”.

For Example, to Return the Zone 1 text back to Defaults;

If during the programming of Zone 1 text [PROG]-[1]-[ENTER] you wished to return back to the default text, simply

Press and hold the “CONTROL” button followed within 2 seconds by “2” if using an AAP Keypad. If using a Crow

Keypad press and hold the “B” button for 2 seconds, and the text will return to the default settings.

If you wished to return to the last saved version of the text simply Press and hold the “CONTROL” button followed

within 2 seconds by “1” if using an AAP Keypad. If using a Crow Keypad press and hold the “A” button for 2

seconds and the last saved text for zone one will appear.

NOTE: If the last saved version of text for Zone 1 was in fact the default setting, then pressing “Control” then “1” or

“A” will return the default text anyway.

COPYING TEXT TO ANOTHER LCD KEYPAD

If more than one LCD keypad is connected to the panel, it is possible to copy the edited Text from one LCD keypad

to all other LCD keypads connected to the same panel.

If using an AAP Keypad, while in “Local Edit Mode” at the keypad with the edited text press “Control” followed within

2 seconds by “3”. If using a Crow Keypad pressing the “CHIME” button for 2 seconds while in “Local Edit Mode” will

perform the transfer. The text in your keypad will be transferred to all other LCD keypads connected to the panel.

EXITING LOCAL EDIT PROGRAM MODE

Press the <PROGRAM> then <ENTER> and the LCD keypad will leave Local Edit Mode and return to Idle Mode.

Name <A..Z

LITE 64

Areas <A..Z>

BCDEFGHIJKLMNOP

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 102 103

Sin comentarios

AAP Elite S series Especificaciones Pagina 15