AAP Elite S series Especificaciones descargar pdf (Pagina 52)

Page 52

SETUP AND DIAGNOSTIC DATA

SETUP AND DIAGNOSTIC DATASETUP AND DIAGNOSTIC DATA

SETUP AND DIAGNOSTIC DATA

DYNAMIC DATA - P1090E-P1093E

These addresses are used to provide real time feedback from the panel as to the current status. They are intended

as view only addresses and only available in installer program mode.

P1090E Display keyboard address - Entering this program location will cause the panel to display the keypad

address (address 1-8).

P1091E Display Areas assigned to this keypad - Entering this program address will cause the keypad you are

using to display it's currently assigned Areas.

P1092E Display software version - Entering this program address will cause the keypad you are using to

display the panel software version number.

P1093E Active Time-Zones - If Time Zones are being used, by entering in this address while in Installation

Program Mode the panel will display any of the 8 time zones currently active. If 1-8 are On they indicate

active time zones.

START PRINTING THE EVENT BUFFER - P1094E

P1094E Start Event Printing - The alarm system stores the last 255 events in a non-volatile memory. Each

event has a time and date when the event occurred plus a description of the event. These events can be

printed to a serial printer if required. To print the events, a Serial Board must be plugged into the panel

(with the link set to printer on the serial board) and connected to a printer with an RS232 input. A user

with permission to print (e.g. P221E-P240E option 3 on) must enter client program mode (P-code-E),

then enter P1094E. The entire contents of the event buffer will be sent to the printer.

ANSWER AN IN-COMING CALL - P1095E

P1095E Answer an In-coming Call - For security reasons the installer may have programmed the panel so that

it can only answer an in-coming call if authorised by a user on-site. This would generally be used to

allow a PC connection to the panel. A user with permission to answer an in-coming call (e.g. P221E-

P240E option 4 on) must enter client program mode (P-code-E), then enter P1095E while the phone line

is ringing. The panel will then answer the call and allow the PC connection to be made.

START WALK TEST MODE - P1096E

P1096E Walk-test mode - When in Installation or Client Program mode, entering P1096E will turn On walk-test

mode. The keypad buzzer will beep at one second intervals to show that walk-test mode is active.

When in walk test mode the activated zone numbers will latch on at the keypad display. The Installer or

User can then walk past all of the detectors and return to the keypad to verify that they are functioning

correctly at the panel. The walk-test results are also stored in memory so they can be viewed at a later

time if required. Pressing any button will terminate walk-test mode and force the panel out of program

mode.

TEMPORARY OUTPUT DISABLE - P1097E

P1097E Temporary Output Disable - This address allows a technician to select any output/s to be temporarily

disabled for one alarm or armed cycle, e.g. by turning on 1-8 at P1097E then leaving program mode, the

selected outputs will not turn on following an alarm. The technician is now free to arm the system to test

all monitoring signals without having all of the internal & external alarms activating. When the alarm is

reset or disarmed all outputs will now work normally again.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 102 103

Comentarios a estos manuales

Sin comentarios

AAP Elite S series Especificaciones Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad AAP Elite S series