AAP Elite S series Especificaciones descargar pdf (Pagina 18)

Page 18

TO CLEAR PROGRAM INFORMATION (From Installation Mode Only)

If you wish to default the panel and start programming with a known set of parameters you can follow the sequence

below.

e.g. To reset ALL parameters to the factory settings

Press <PROGRAM> - 1105 - <ENTER>

1 beep

Then press - 1105 - <ENTER>

3 beeps

To ensure that the panel cannot be accidentally defaulted, the default address must be entered in twice as per the

example above before the default operation will occur.

TO EXIT PROGRAM MODES

To exit program modes when you have finished programming:

Press <PROGRAM> - <ENTER>

The panel is now back in normal Run Mode and any program changes you have made will be in effect.

Note: While in Program Mode, Tampers and 24 hour alarms are disabled which allows quiet access to the panel,

satellite siren units etc. Also, the panel cannot be armed while in program mode. On exiting program mode, all inputs

are scanned and if any tampers or 24Hr alarms are present an activation will occur.

Note: Where there are multiple options at one address, the numbers “0” & “9” have been reserved. Entering

a “0” at the address will turn all options OFF at that address whereas entering a “9” will turn all options ON

at that address.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 102 103

Sin comentarios

AAP Elite S series Especificaciones Pagina 18