AAP Elite S series Especificaciones descargar pdf (Pagina 17)

Page 17

ACCESSING PROGRAM MODE FOR THE FIRST TIME

ACCESSING PROGRAM MODE FOR THE FIRST TIMEACCESSING PROGRAM MODE FOR THE FIRST TIME

ACCESSING PROGRAM MODE FOR THE FIRST TIME

GENERAL INFORMATION

There are two program modes in the panel. The first is the “Client” Program Mode to allow a system User to Add,

Change or Delete User Codes.

The second mode is the “Installer” Program Mode. The Installer Program Mode allows ALL programmed data to

be changed. Access to both Modes is described below.

ACCESS TO INSTALLER PROGRAM MODE ON POWER UP

When power is applied to the controller for the first time, (with the panel tamper input open and none of the

Areas either Armed or in Stay mode), the panel will inhibit tamper alarms and ready the panel to enter

INSTALLATION PROGRAM Mode (unless the Installer Lock-out option P741E4E has previously been enabled). At

this point you can go to any keypad which is connected to the panel and;

Press –”PROGRAM”-”ENTER”

This will automatically put the keypad into Installation Program mode. The LCD display will show “INSTALLER

MODE”.

ACCESS TO PROGRAM MODES FROM RUN MODE

Before you can enter program mode from the normal Run Mode, the panel must be disarmed and not in stay mode.

Then to access CLIENT MODE;

Press <PROGRAM> - <Code 1 (or Master Code)> - <ENTER>

LCD displays “CLIENT MODE”

Note: Default Master Code (Code 1) is 1,2,3

You are now in Client Program Mode. When you are in Client programming mode, the options set at P221E-P240E

define what areas of programming you may change.

To enter INSTALLER MODE from CLIENT MODE;

Press <PROGRAM> - <Install Code> - <ENTER>

LCD displays “INSTALLER MODE”

Note: Default Installer Code (P410E) is 0,0,0,0,0,0

By default the installer can go directly to Installer Program Mode from Normal Run mode provided No Areas are

Armed or in Stay Mode. The Installer Mode direct option can be disabled by turning Off Option 3 at address P741E.

HOW TO PROGRAM YOUR PANEL

Once you have accessed one of the Program Modes the programming sequence follows the example below;

3 short beeps if OK - 1 long beep if error

The LCD will display current value or status

Enter the new data

3 short beeps if OK - 1 long beep if error

An example of programming is shown below. Here we are programming User Code 23 (P23E) with the code 2580.

P 23 E 2,5,8,0 E

In the example above the <P> represents the PROGRAM key, <23> represents the actual address for User Code

23, 2580 is the data and <E> represents the ENTER key.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 102 103

Sin comentarios

AAP Elite S series Especificaciones Pagina 17